Buying a Used TBM: What to Inspect, Refurbishment Scope and Lead Time
Used TBMs are increasingly attractive for long hard-rock and cold-climate drives across CIS countries, where capital budgets are tight and schedules long. The machine's true condition sits in five places: cutterhead structure and cutter housings, main bearing and gearbox runout, main drive and shield seals, screw conveyor wear liners and auger flighting, and hydraulic/electrical condition. Ask for bearing vibration records, seal replacement history and recent oil analysis before agreeing to any price. Refurbishment scope should be fixed in writing. Typical work covers seal and bearing replacement, hydraulic hose and valve overhaul, electrical cabinet upgrades, wear-plate renewal and cutterhead retrofit — new housings, hardened wear protection or a change of cutter spacing for harder rock. Cutterhead retrofit is where a second-hand machine can be adapted to a new geology rather than merely restored. Lead time is the deciding factor. A refurbished machine ready from stock can ship in weeks, while a new build runs far longer — the practical difference on a winter-constrained CIS site. Spares availability is the real risk reducer: OUSUN, based in Deyang, Sichuan, supplies disc cutters, segment bolts, seals, screw conveyor parts and hydraulic/electrical spares with roughly 2-4 week lead times, plus new and refurbished EPB, slurry, hard-rock and pipe jacking machines. Contact info@tunnel-boring.com.