Back to News
11/16/2026

Double Shield TBM Advance Rate in Hard Rock: 19-Inch Cutters and Segment Lining

In competent to moderately fractured hard rock, a Double Shield TBM separates the machine into a gripper-mounted front shield and a telescopic rear shield. The cutterhead keeps boring while the segment erector builds the ring under shield protection, so excavation and lining overlap instead of alternating as on a single-shield machine. The result is a higher net advance rate, immediate ground support behind the cutterhead, and a crew working under steel rather than exposed rock.

The cutting side matters just as much. 19-inch heavy-duty disc cutters allow higher thrust per cutter and a thicker ring profile, which usually means fewer cutter changes and lower specific energy in abrasive rock. Wear reduction comes from matching cutter type and spacing to the rock mass, tracking wear rates, and keeping bearings, seals and cutterhead hydraulics in condition. Because OUSUN supplies interchangeable cutters, seals, segment bolts and screw conveyor parts from the Deyang cluster with roughly 2-4 week lead times, wear-part planning can follow the TBM cycle rather than the other way round.

For long mountain drives in CIS countries, the constraint is often logistics as much as geology. Cold winters compress the transport window, and a stalled cutterhead in February is far more expensive than a stocked warehouse in October. Engineers should size cutter and seal inventories against metres-per-cutter forecasts, review hydraulic oil viscosity and grease grades for low temperature, and confirm segment bolt and gasket supply before the season closes. The takeaway: continuous boring only pays off when the wear parts arrive on schedule.